fishingmag.co.nz

The Canterbury Lure Rod is used for Salmon and Searun Trout Fishing - New Zealand Salmon Fishing

 
Departments
NZ Fishes
Freshwater Places
Saltwater Places
Surfcasting Places
Fishingmag Shop
Allan's Fishing Blog
Knots
Rigs
Sinkers
Fish Hooks
How To
Feathered Lures
Dry Flies
Wet Flies
Nymphs
Saltwater Fly
Baits
Freshwater Lures
Salmon Lures
Saltwater Lures
Competitions
YouTube Videos
4x4s Vehicles
Fishing Photos
Whitebaiting
Trout Fishing
Salmon Angling
Deep Sea Fishing
Surfcasting
Game Fishing
Boats
Books
Tackle
Message Board
Home

Canterbury Lure Rod

Canterbury Lure Rod
Canterbury lure rod outfit. Note two Hope's Silveries fished below a chain of small leads. This arrangement is less prone to becoming snagged.
canterbury Lure Rod
A fat salmon taken on the Canterbury lure rod!

The Canterbury lure rod is a local innovation designed to get a lure down to the bottom of Canterbury's fast flowing salmon rivers. The current near the mouth of rivers like the Rakaia and Rangitata can be so fast that zed spinners simply plane to the surface. Salmon stick close to the stones when entering the river because the water at the bottom flows slower than at the surface.

A Canterbury lure rod is a type of heavy fly rod about ten feet in length. A large capacity single action fly reel is used to store the heavy monofilament line used instead of a conventional fly line. The reason for the heavy mono (30-40 lb) is so that it doesn't cut into your fingers. To the end of the mono is attached a lead weight and swivel arrangement, and to this about 2 metres of lighter mono (say 10-15 lb) is connected and the lure or fly tied at the end.

The rod is quiet specialised because it must have a slow action to be able to cast the heavy weights, of around 2 ounces, slowly enough without tangling the long leader. The rod must also be powerful enough to fight 40 pounds of angry salmon intent on heading back out to sea. The reel must have an equally strong drag system to sustain a potentially long and sustained fight between angler and fish. At the same time because much short casting is involved the whole must not be excessively heavy.

The Canterbury lure rod has had much bad press over the years. I believe there are several reasons for this. Firstly, it is a method that can be used in narrow channels, and milky water, where there is a good chance of foul hooking fish. It is also true that there is probably more likelihood of foul hooking with a lure rod than a Zed spinner. If a salmon is foul hooked it is soon obvious. Instead of the typical head shaking, nodding, and solid heavy pull, (not unlike hooking a floating log with its own outboard) a foul hooked fish is far more likely to perform acrobatics, and shoot up out of the water. It will most likely be side on to the line it will be very difficult to play and lead, and so will take a long time to bring in. In this situation it is best to simply tighten up on your line and break the fish off. It is better to try to hook another legally in the mouth than to waste an hour playing a fish you are going to have to release anyway.

Some "scoundrels" have given the Canterbury lure rod a bad name by not breaking-off foul hooked fish and releasing them but instead keeping them. Worse still is the quite illegal practice of shortening the leader and ripping the fly across the current in a deliberate attempt to illegally foul hook fish, which it goes without saying, they have no intention of releasing. This practice of "scratching" or "stroke hauling" is quite rightly not on. However, you can't blame the lure rod angler who fishes his gear properly and releases any foul hooked fish for the actions of a few idiots, any more than you can consider banning cars because they kill people.

A second reason that lure rods are unpopular with some salmon anglers is because a lure angler needs more room to fish his gear. The lure angler swings his weighted line around behind him and out over the water and upstream, rather than casting as one would with a conventional fly fishing outfit. Obviously this requires more space if a sharp pain in the ear of a neighbouring angler is to be avoided. A minimum of about 15 feet on either side is needed to fish a Canterbury lure rod. Spinning on the other hand allows many anglers to fish in close proximity, with their shoulders almost touching. On days when very large numbers of anglers are crowding the gut, many spin anglers resent the space hogging antics of some lure fishermen. In this situation I would either: move somewhere else if I wanted to continue fishing the lure rod: or otherwise change to spinning gear. This is not to say that it shouldn't be a case of "first up best dressed" in that if you were there first with your lure rod, spin anglers should go somewhere else. But in a crowded situation who needs the hassle of having to check repeatedly that the "coast is clear" before casting. I have witnessed a few arguments on this one.

Once you settle into the rhythm of casting with the lure rod it it becomes surprisingly enjoyable. Fishingmag.co.nz
Once you settle into the rhythm of casting with the lure rod it it becomes surprisingly enjoyable.
Lure patterns - Canterbury
Typical lures used when fishing the Canterbury Lure Rod for both trout and salmon. Note the silvery in the second column. This is the baitfish most of these lures represent.

Thirdly, other anglers don't enjoy fishing with a Canterbury lure rod. I have spoken to many salmon anglers who have tried it and didn't like it. The need for continuous casting, combined with the weight of rod, reel and sinker simply doesn't appeal!

On a recent trip down to the mouth of the Rakaia River, I noted that of the 100 odd anglers I could see fishing the lower reaches, 90 percent were fishing a Canterbury lure rod. Many were hut owners and locals. Later in the season when good numbers of salmon begin running, the ratio of lure anglers to spin fishermen will drop considerably!

The lure rod is the best option when the river is still running high and carrying a bit of colour. Searun brown trout will readily take a fly in fast water near the mouths of Canterbury's big rivers, as they chase the silveries, and are a welcome bonus when fishing the lure rod.

Once you settle into the rhythm of casting with the lure rod it it becomes surprisingly easy and enjoyable. You don't need to cast very far 15-20m maximum. Cast upstream and follow the angle of your line with the rod tip. You can cast over head style or simply let the lead swing out like a pendulum. Try to keep a reasonably tight line at all times to stay in touch with your lures. When a fish hits lift your rod tip. Even if you only suspect a fish has touched your lure lift your rod tip immediately to set the hook.

 

Take a look at the Shimano Moocher reel. You might also be interested what salmon eat at sea? History of salmon fishing in the Waitaki River and Line of Salmon Anglers at the Rangitata River. Read about Otago Harbour Salmon Fishing. Learn how to fix that annoying leak in your waders. Much depends on the speed at which you wind in your zed spinners. Take a look at super salmon spinners.

Salmon Angling in New Zealand

 
 

 

© fishingmag.co.nz 1999 - 2014